LOBACARE® V6 Finish is a high quality water-based polyurethane permanent care product used to protect finished floors. It protects the finished floor by forming a protective layer against fine scratches and wear marks. It also works to prevent preterm wear-out and actively prolongs the durability of the surface. Available in Matt Satin or Gloss Finish.

Application

To be used with the LOBATOOL Wischwiesel. Recommended for use on hardwood timber floors and cork floors. It is recommended that preliminary tests are performed to check for bonding inadequacies between V6 Finish and the existing finish.
Prior to application, remove any loose dirt and dust from the floor surface with a vacuum or broom. Stubborn dirt or residue must be removed. Finish is pre-applied to the floor in sections and then applied in an even layer. Lay the applicator as flat as possible on the floor and do not lift. Do not use pressure. Start at one side of the room and then work from wall to wall towards the opposite side of the room with the exit door. A room should always be completely treated in one go. Never rework the floor while it is drying since this can lead to streak formation. Can be walked on after 1-2 hours; full traffic capacity and coverage after 12 hours. Wash application tools immediately with water.

Removal

V6 Finish is a permanent care product, therefore once dried on the flooring surface, removal is by mechanical (sanding) means.